NOTE: the indication Tare C indicates that the tare displayed is a
"coded" tare to which a numerical code has been assigned ( par.
5.2.12 on page 1-47 ).
✔
If multiple tares were set during installation:
Tare T: acquired tare value + unit of measurement
Tare 1 PT: preset tare 1 value + unit of
measurement
Tare 2 PT: preset tare 2 value + unit of
measurement
Or
Tare C PT: preset tare value + unit of
measurement
Tare 1 PT: preset tare 1 value + unit of
measurement
Tare 2 PT: preset tare 2 value + unit of
measurement
Or
Tare PT: "non coded" tare value + unit of
measurement
Tare 1 PT: preset tare 1 value + unit of
measurement
Tare 2 PT: preset tare 2 value + unit of
measurement
The indications and PT will be illuminated.
NOTE: Tare 1 and Tare 2 may also be recalled via numeric
code ( par. 5.2.13 on page 1-48 ).
✔ Extraction
This display mode is only possible if loading or unloading extraction
operating mode is selected (see par. 5.4.3 on page 1-54 and par.
5.4.4 on page 1-55 ).
The display shows the gross weight, the extracted weight and the
weighing symbols.
D410
1-44
To Next Page
Loading...