Repair work at the inner and outer chamber
7.2 Replacing the closing device of the glass door
Spare parts: Turn-lock fastener KB/E5 complete (order no. 6002-0316)
Disk spring DIN2093-C 12.5 x 6.2 x 0.35 (order no. 3003-0034)
Washer DIN9021-A 3.2 A2 140 (order no. 3003-0025)
Screw DIN7985-A M3x6-4.8 zinc coated (order no. 3001-0029)
Necessary tools: Crosstip screwdriver, size 2
1. Remove the cap (G) and the screw (F) below with its washer (E).
2. Remove the turn-lock fastener (C) from the press-fit bush (B).
3. Mount the new closing device by following steps 1 to 2 in reverse order.
Locking plate with press-fit bush
Figure 18: Replacing the closing device of the glass door
Service Manual KBF (E5.2) 04-2015 57
To Next Page
Loading...
