MK / MKT (E5) 03/2019 page 123/158
Electrical data (model version MK056-230V)
IP-system of protection acc. to EN 60529
Nominal voltage (+/-10%) at 50 Hz power
frequency
V 230 400 400 400
Power plug
IEC con-
nector plug
CEE plug 5
poles
poles
poles
Over-voltage category acc. to IEC 61010-1
Pollution degree acc. to IEC 61010-1
Over-current release category B, internal
Different electrical data for chambers constructed for the USA and Canada
(model version MK056-240V)
Nominal voltage (+/-10%) at 60 Hz power
frequency
V 240 -- -- --
Current type 2~ -- -- --
Electrical data of the voltage and frequency changer
IP-system of protection acc. to EN 60529
Nominal voltage (+/-10%)
at 60 Hz power frequency (input side)
V -- 480 480 480
Over-voltage category acc. to IEC 61010-1
Pollution degree acc. to IEC 61010-1
Environment-specific data
Noise level (mean value) with optional
compressed air dryer (short-term)
dB(A) *** 85 85 85
Noise level (mean value) with voltage and
frequency changer
dB(A) -- 67 67 67
Energy consumption at +20 °C / 68 °F
Filling weight of refrigerant R 452A (GWP
2140)
kg / lbs. 1.00 / 2.20 1,20 / 2.65 1,40 / 3.09 3,20 / 7.10
*** Data not yet determined
Note: Chambers with voltage and frequency changer: Average heating up time reduced by 0.3 K/min
each.
All technical data is specified for unloaded chambers with standard equipment at an ambient temperature
of +22 °C +/- 3 °C / 71.6 °F +/- 5.4 °F and a power supply voltage fluctuation of +/-10%. Technical data is
determined in accordance to BINDER Factory Standard Part 2:2015 and DIN 12880:2007.
All indications are average values, typical for chambers produced in series. We reserve the right to
change technical specifications at any time.
If the chamber is fully loaded, the specified heating up and cooling down times may vary ac-
cording to the load.