Clear OVP Condition by Decreasing the Output Voltage
1. Decrease the output voltage level bellow OVP trip level
Press Limit key and enter limit mode. Limit values of voltage and current will
be displayed. ovp and lmt indicators will also be displayed.
Adjust for output voltage limit to a lower value than the OVP trip level.
Press Limit key to exit limit mode.
2. Enter OVP menu and clear OVP condition
Here you check that the OVP trip level is greater than the output voltage limit
you set. If it isn’t, go to step 1.
Don’t adjust OVP trip level!
Clear OVP condition by turning the knob and selecting OVP Clear option:
After that, press OVP / Secure key. The power supply will display:
and after several seconds it will return to normal mode. ovp indicator will be
displayed (the OVP circuit is still enabled).
Important note!
If you enter OVP menu and no action takes place for approx. 20 seconds, the
power supply will leave the OVP menu. No Change message is displayed and
the power supply returns to the previous state (the state before entering OVP
menu).
OVP Clear
To Next Page
Loading...
Need help?
General
