Addressed commands: they are byte commands sent by the Controller only to
the addressed Listeners. So these commands are sent with address bytes.
GET (Groupe Execute Trigger)
This command is equivalent to the *TRG command. For more
information about trigger subsystem of the power supply, please refer
to Trigger Subsystem section.
SDC (Selected Device Clear)
Resets the power supply to its default state. This command is
equivalent to the *RST command, so the power supply will go to reset
state.
GTL (Go To Local)
The power supply will go to local mode. It will receive commands
only from front panel.
To Next Page
Loading...
Need help?
General
