106
Switching to radio mode
If you are in CD, MP3, Bluetooth streaming,
CD changer or AUX mode,
press the TUNER button ?
or
press the SOURCE button 4 repeat-
edly until "TUNER" appears on the dis-
play.
Selecting the static/ dynamic
radio mode (FM only)
Static and dynamic radio mode
In the static radio mode, four memory
banks (FM1, FM2, FM3 and FMT) are avail-
able in FM mode. You can store six stations
in each of these memory banks. The receiv-
ing unit automatically adjusts the best re-
ceivable frequency of the station for each
of the stored stations.
In the dynamic radio mode, the adjusted
station is played via the fi rst tuner and the
second tuner searches in the background
for additional receivable stations. All cur-
rently receivable stations are displayed in
dynamic lists.
Up to 4 dynamic lists and each with up to
6 currently receivable stations are avail-
able. The 6 stations of a dynamic list are
shown on the display as assignments of the
6 softkeys (as frequency or, if available, as
station name). The stations are constantly
updated so that you can always access re-
ceivable stations.
Static radio mode with one or two
antennas
If you connected only one antenna to the
device and set it up in the menu (see the
section "Setting the number of antennas" in
쏅
쏅
this chapter), the device plays back the con-
fi gured station with one tuner and searches
for the best frequency of the adjusted sta-
tion with the second tuner (with activated
RDS function).
If you connected two antennas to the device
and set them up in the menu, the adjusted
station is received with both antennas in
DDA (Digital Directional Antenna) radio
mode. In the process, the TwinCeiver con-
tinuously analyses the signals of both an-
tennas and calculates a "clean signal" from
them to reduce reception interferences.
This process developed by Blaupunkt cor-
responds to a directional aerial with re-
spect to its mode of operation. Particularly
in areas with reception interferences due
to refl ections from buildings, mountains,
etc., the reception quality is signifi cantly
improved.
In exceptional cases, e.g. reception of two
different stations on the same frequency,
it may lead to an undesirable reception be-
haviour. In such a case, you should select
the dynamic radio mode (see the following
section "Selecting the static or dynamic ra-
dio mode").
Selecting the static or dynamic radio
mode
To switch the radio mode between static
and dynamic,
press the TUNER button ?
The "Tuner" menu is displayed.
Press the NEXT button 2.
Press the "Tuner 2" softkey 8.
Press the "Dynamic List" softkey 6 for
the dynamic mode or "Presets" ; for
the static mode.
쏅
쏅
쏅
쏅
Radio mode
02_BREMEN_MP78_gb.indd 10602_BREMEN_MP78_gb.indd 106 04.07.2008 10:17:21 Uhr04.07.2008 10:17:21 Uhr
To Next Page
Loading...
