144
Press the "Center" softkey ;.
Press the "Phase" softkey 7.
Select the desired setting by pressing
the
> or button @ or > or
button @.
When you have fi nished making your
changes,
press the OK button B repeatedly un-
til you reach the desired menu level for
additional settings or completely exit
the menu.
Adjusting high-pass fi lters for the centre
speaker
Press the MENU button A.
Press the softkey "Audio Settings" 6.
Press the NEXT button 2.
Press the "Center" softkey ;.
press the "HighPass" softkey ;.
The display shows the setting options
"Frequency" 6 (from 40 Hz to 10,000 Hz),
"Slope" 7 and "Characteristics" 8 each
with the current settings.
Press the corresponding softkey ;.
Select the desired setting by pressing
the
> or button @ (down) or
> or
button @ (up).
When you have fi nished making your
changes,
press the OK button B repeatedly un-
til you reach the desired menu level for
additional settings or completely exit
the menu.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Enhanced sound settings in
crossover mode
In crossover mode, the high frequencies
(treble) are transmitted via the front chan-
nels, the centre frequencies (middle) via
the rear channels and the low frequencies
(bass) via a connected subwoofer. For tre-
ble, middle and bass, you can adjust the
level (from –10 dB to +10 dB) and a high-
pass, low-pass or subsonic fi lter in each
case.
Switching crossover mode on/off
Note:
If you switched on the crossover mode,
the DSA setting options for the equal-
izer and the stage sound are automati-
cally adjusted.
To switch the crossover mode on or off,
press the MENU button A.
Press the NEXT button 2.
Press the "Various Settings" soft-
key ;.
Press the "Crossover" softkey 7
to switch on the crossover mode or
"Normal" 6 to switch off the crosso-
ver mode.
The softkey with the selected setting is
brightly highlighted.
When you have fi nished making your
changes,
press the OK button B repeatedly un-
til you reach the desired menu level for
additional settings or completely exit
the menu.
쏅
쏅
쏅
쏅
쏅
Enhanced sound settings
02_BREMEN_MP78_gb.indd 14402_BREMEN_MP78_gb.indd 144 04.07.2008 10:17:31 Uhr04.07.2008 10:17:31 Uhr
To Next Page
Loading...
