141
ENGLISH
Press the MENU button A.
Press the softkey "Audio Settings" 6.
Press the softkey "Fader" 8.
Adjust the front/rear volume distribu-
tion by pressing the
> or button
@ (down) or
> or @ (up).
When you have fi nished making your
changes,
press the OK button B repeatedly un-
til you reach the desired menu level for
additional settings or completely exit
the menu.
X-Bass
X-Bass allows you to increase the bass at
low volume. The selected X-Bass setting
applies to all audio sources.
You can select one of 5 X-Bass frequen-
cies between 32 Hz and 80 Hz adjust the
level for the selected frequency from 0 (no
X-Bass boost) to 6 (maximum).
Press the MENU button A.
Press the softkey "Audio Settings" 6.
Press the softkey "X-Bass" :.
Select the X-Bass frequency by press-
ing the
or button >.
Adjust the X-Bass level by pressing the
or button @.
When you have fi nished making your
changes,
press the OK button B repeatedly un-
til you reach the desired menu level for
additional settings or completely exit
the menu.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Enhanced sound settings
You can connect a subwoofer and a centre
speaker to this device.
To optimise the sound for the use of sub-
woofer a centre speaker in normal mode
(crossover mode is not switched on), you
can:
adjust one high-pass fi lter each for
the front and rear loudspeakers
(channels).
adjust the high-pass fi lter, phase shift
and level for the centre speaker.
adjust a low-pass fi lter, subsonic fi l-
ter, phase shift and level for the sub-
woofer.
The following adjustment options are avail-
able for high-pass and low-pass fi lters:
Frequency : Select the cut-off frequen-
cy up to which lower frequencies (high-
pass) or higher frequencies (low-pass)
should be blocked. Only frequencies
above the cut-off frequency (high-
pass) or below the cut-off frequency
(low-pass) are passed on to the loud-
speakers.
Slope : Adjust the attenuation of the fi l-
ter. A high value ensures a steep fi lter
slope, which translates to a strict sepa-
ration between blocked and forwarded
frequencies. A low value ensures a
soft separation, which translates to a
gradual transition from blocked to for-
warded frequencies. The settings "Flat"
or 12, 18 or 24 dB/Oct are available for
attenuation.
Characteristics : Select the charac-
teristics of the fi lter. Available set-
tings are "Bessel", "Butterworth" and
"Chebychev".
•
•
•
•
•
•
Sound Enhanced sound settings
02_BREMEN_MP78_gb.indd 14102_BREMEN_MP78_gb.indd 141 04.07.2008 10:17:30 Uhr04.07.2008 10:17:30 Uhr
To Next Page
Loading...
