Blaupunkt Bremen MP78 - Storing Stations; Storing Stations Automatically (Travel Store); Listening to Stored Stations; Scanning Receivable Stations (Scan)

110
Note:
In the tuner region "EUROPE", the sen-
sitivity value adjusted for AM applies to
the wavebands MW, LW and SW.
Storing stations
Storing stations manually
Select the desired waveband or memory
bank.
Tune into the desired station.
Briefl y press on the softkeys 6 to
;.
The assignment of all six memory locations
is displayed.
Press and hold down one of the softkeys
6 to ; for longer than 2 seconds to
assign the station to that button.
A confi rmation beep sounds. The station is
stored at the selected memory location.
Storing stations automatically
( Travel Store)
You can automatically store the six strongest
FM stations in the region. The stations are
stored in the FMT memory bank. In the tun-
er region "USA" or "SOUTH AMERICA", you
can also automatically store the 6 strongest
AM stations in the AMT memory bank.
Note:
Stations previously stored in the FMT
or AMT bank are deleted.
Select the FM or AM waveband.
Press the TUNER button ?
The "Tuner" menu is displayed.
Press the "Travel Store" softkey 9.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
The storing procedure begins. "Travel Store"
appears on the display. After the process
has completed, the radio will play the sta-
tion that is stored in memory location 1 of
the FMT or AMT memory bank.
Listening to stored stations
Select the memory bank or waveband.
Briefl y press on the softkeys 6 to
;.
The assignment of all six memory locations
is displayed.
Press the softkey 6 to ; where the
desired station is stored.
The stored station is played if it can be re-
ceived.
Note:
The memory location assignment is
hidden again approx. 16 seconds after
pressing the last softkey. To hide it ear-
lier, press the TUNER button ?.
Scanning receivable stations
( Scan)
You can use the scan function to play all
the receivable stations briefl y. The scan-
ning time can be adjusted in the menu from
5 to 30 seconds (see the section "Setting
the scanning time (Scan Time)" in this
chapter).
Starting Scan
Press and hold down the OK button B
for longer than 2 seconds.
The radio scans the next receivable station.
The display shows "SCAN".
쏅
쏅
쏅
쏅
Radio mode
02_BREMEN_MP78_gb.indd 11002_BREMEN_MP78_gb.indd 110 04.07.2008 10:17:22 Uhr04.07.2008 10:17:22 Uhr