Blaupunkt Bremen MP78 - Page 145

145
ENGLISH
Adjusting the treble
For treble playback, you can adjust the level
and a High-pass fi lter.
Press the MENU button A.
Press the softkey "Audio Settings" 6.
Press the NEXT button 2.
Press the "Tweeter" softkey 6.
The display shows the selection between
"HighPass" (high-pass fi lter), "Phase"
(phase shift) and "Gain" (level).
To adjust the high-pass fi lter,
Press the "HighPass" softkey ;.
The display shows the setting options
"Frequency" 6 (from 225 Hz to 10,000 Hz),
"Slope" 7 and "Characteristics" 8 each
with the current settings.
Press the corresponding softkey.
Select the desired setting by pressing
the
> or button @ (down) or
> or
button @ (up).
Press the OK button B.
To adjust the phase shift,
press the "Phase" softkey 7.
Adjust the desired value by pressing
the
> or button @ or > or
button @.
To adjust the gain,
press the "Gain" softkey 6.
Adjust the desired level by pressing the
> or button @ (down) or >
or
@ (up).
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
When you have fi nished making your
changes,
press the OK button B repeatedly un-
til you reach the desired menu level for
additional settings or completely exit
the menu.
Adjusting the middle
For middle playback, you can adjust the
level and a frequency range. The frequency
range for the middle can be restricted by
a high-pass fi lter and a low-pass fi lter. The
high-pass fi lter is used to defi ne the lower
cut-off frequency, the low-pass fi lter the up-
per cut-off frequency.
Press the MENU button A.
Press the softkey "Audio Settings" 6.
Press the NEXT button 2.
Press the "MidRange" softkey 7.
The display shows the selection between
"HighPass" (high-pass fi lter), "LowPass"
(low-pass fi lter), "Phase" (phase shift) and
"Gain" (level).
To adjust the high-pass or low-pass fi lter,
press the "HighPass" softkey ; (high-
pass fi lter) or "LowPass" : (low-pass
fi lter).
The display shows the setting options
"Frequency" 6 (HighPass: 40 Hz –
10,000 Hz, LowPass: 225 Hz – 10,000 Hz),
"Slope" 7 and "Characteristics" 8 each
with the current settings.
Press the corresponding softkey.
Select the desired setting by pressing
the
> or button @ (down) or
> or
button @ (up).
Press the OK button B.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Enhanced sound settings
02_BREMEN_MP78_gb.indd 14502_BREMEN_MP78_gb.indd 145 04.07.2008 10:17:32 Uhr04.07.2008 10:17:32 Uhr