Bluetti EP600 - Safety Instructions and Precautions; 1.1 General Safety Guidelines; 1.2 Installation & Electrical Safety

EP600 Energy Storage System User Manual
4
1. SAFETY INSTRUCTION
1.1 Safety instruction
Please read the guidebook before using the equipment.
The technician responsible for installing must hold an electrician certificate, because some components
might electric charged or heat up when the EP600 energy storage system running, improper
operation, incorrectly install or operate might cause the serious damage of personal safety andproperty.
Don't place the equipment near the heat producer, it's forbidden to place or power on the Energy Storage
System in the environment with flammable，explosive gas and smoke.
Except the authorized technician, please don't replace any components of Energy Storage System
arbitrarily.There's no replaceable component in the package.
Please use the Energy Storage System in the well-ventilated environment, don't block the air vent of Energy
Storage System, poor ventilate might cause the irreversible damage to the Energy Storage System.
Please don't place other object on the top of Energy Storage System when operating or settling.
Please don't move the Energy Storage System when it's operating, because the vibration and the shock
produce from movement might cause the internal hardware failure.
Warning
Please don't insert foreign object into any port of Energy Storage System. Please be
aware of operating and keep children away from the Energy Storage System. If the
Energy Storage System is on fire, please use dry powder extinguisher to put out the
fire.
For security, please use the cables configured by the original factory.
We will not responsible for the equipment damage cause by the third-party
device.
Instruction
The safety requirement of the guidebook aren't including the whole technical
requirement but a supplementary instruction, the actual operation are contact with
the on-site condition.
1.2 Precaution of installation
Attention
Please attention, it's forbidden to power on EP600 energy storage
system in the process of installation 。
Please measure the voltage of contact point to make sure there's no risk of electric shock before touching