Bluetti EP600 - Communication Methods

EP600 Energy Storage System User Manual
59

Check whether the battery pack and inverter are secure and stable;
 Move tools and parts away from the Energy Storage System;
 Push the circuit breaker handle of all battery packs up to the ON position
 Then press and hold the power button of any battery pack for 3 seconds until the green indicator on the
button lights up (or turn on the PV switch of the inverter, or turn on the grid switch of the inverter);

All connected battery packs will be fully activated and the indicator lights will be on
Note: If the indicator lights of some battery packs are not on, check the communication cable.
To turn off the battery pack, please follow the steps below:
 Turn off the PV switch of the inverter;

Turn off the grid switch of the inverter;

Press the power button of any battery pack until the green indicator light on the button starts to flash;
 The battery pack will enter the shutdown process, during which the indicator light will continue to
flash;
 After the indicator light stops flashing and goes out, the shutdown process of the B500 is complete ;
 Finally, push the battery pack circuit breaker handle down to the OFF position.
6.10 Communication methods
The EP600 energy storage system is connected to the IOT controller, and the inverter information can be
seen on the mobile APP through Bluetooth or WiFi. And remotely control the working mode of the inverter.
The working information of the system (power generation, alarm, and working status) can be uploaded to
the server through WiFi network.Users can use the APP to view and control the device according to their
needs, which requires registering an account and binding the device by scanning the QR code of EP600.
The IOT controller contain the following communication methods:
communication methods
Remark
Wi-Fi
Standard
Bluetooth
Standard
6.10.1 Overview