EP600 Energy Storage System User Manual
5.4 About installation
5.4.1 Installation Environment Requirements
Choose a dry, tidy place for easy installation
The protection level of the inverter and battery pack is IP65, and can be installed both indoors
and outdoors.(If it is installed outdoors, additional protective measures are necessary to avoid
direct sunlight)
If the system is installed in direct sunlight, the performance of the system may be degraded as the
temperature rises.
Duringthe operation oftheinverter,thetemperature of the bodyandheat sinkwillberelativelyhigh. Do notinstallthe
inverter in aneasilyaccessiblelocation.
No flammable and explosive substances can exist in the installation environment.
Do not install where children can reach
Do not install outdoors in coastal areas, which areas within 500 meters from the coast or
affected by sea breezes. The sedimentation amount of salt spray varies relatively widely
depending on the characteristics of seawater, sea breeze, precipitation, air humidity,
topography and forest coverage in the adjacent sea areas.
The system should be installed in a well-ventilated environment to ensure good heat dissipation.
Do not install the system in low-lying area where water can easily accumulate. Otherwise the
water may leak into the equipment and cause system failure.
Ambient temperature range : -20℃～40℃
Relative humidity:5
～
95%(non-condensing)
Maximum height:2000m
5.4.2 Installation carrier Requirements
Do not install the system on flammable building materials.
Please ensure the ground where you are installing is flat and firm, and can carry the weight of the
installation system.
5.4.3 Installation Angle Requirements
The system is equipped with a base, the base is placed on a flat ground, and the system is installed
by stacking in layers.
The system should be installed close to the wall, and both sides of each layer of equipment need to
be fixed on the wall through brackets.
The system is installed perpendicular to the horizontal floor.
To Next Page
Loading...
