bonitron M3452 - General Specifications

M3452 vR8 EIP/PDP
12
2.3. GENERAL SPECIFICATIONS
Table 2-6: General Specifications
PARAMETER
SPECIFICATION
DC Bus Voltage
325 – 1090 VDC
DC Braking Current
200 – 1600 ADC
Control Voltage
Single Phase, 115, 230, 380, 460, 575 VAC
±10% 50/60 Hz 70 VA
Indicators
DC Bus
Control Power
Active Braking
Network I/O
Inputs
Outputs
Enable
DC Bus Discharge
Fault Reset
Master/Slave Select
Setpoint Adjust
Heat Sink Temperature
Bus Voltage
Fault State
Master/Slave Status
Fault Records
Logic I/O
Inputs – 24V
Outputs – Max 140 VAC / 200 VDC at
100mA
Enable
Fault Reset
DC Bus Discharge
Ready Status
Control I/O
Sharing Control Signal
Operating Temp
0 to 40C
Storage Temp
-20 to 65C
Humidity
Below 90%, non-condensing
Atmosphere
Free of corrosive gas or conductive dust