bora PURU - User Menu Settings and Customization

EN
39
Operation
www.bora.com
7.6 User menu
Certain functions can be set in the user menu.
INFO Below you will find explanations on how to use
the menu and a description of the most important
menu items.
INFO The menu can only be called up if all cooking
zones and the cooktop extractor are inactive. In
addition, there must be no residual heat.
Calling up the user menu
 Switch on the device by pressing the power button

If start-up is successful, the standard display will
appear in the operating panel.
 Long press on the multi-function display.

The menu is called up and the first menu item is
displayed.
Closing the user menu
 Long press on the multi-function display

The menu is closed and the standard display appears.
Navigating the user menu
 Tap the multi-function display

The system moves to the next menu item.

The system automatically adopts and saves set values
when you move to another menu item or close the
menu.
User menu overview
Menu item/Description/Selection area Factory
setting
1 Volume of the acoustic signals (0-9) 4
2 Childproofing feature (On/Off) Off
3 Show and reset filter status
4 Duration of the automatic after-run function
(10, 15, 20 min)
20 min
5 Touch zone reaction speed
(1 slow, 2 medium, 3 fast)
2
6 LED test
7 Permanent pan size recognition Off
8 Software/hardware version
9 Safety shut-down (1 long, 2 medium, 3 short) 2
0 Reset to factory settings
A Super simple mode Off
Tab. 7.4 User menu overview
Showing the remaining time
The cooking zone timer is active and the time counts
down:
 Tap the cooking zone

The remaining time is shown in the multi-function
display.
Changing active timers
 Tap a cooking zone with an active timer

The remaining time is displayed.
 Tap the timer button

The timer is stopped.

The remaining time flashes in the display.

The system changes to timer editing mode.
 Change the set time (see “Setting the time”).
 Confirm the new set time and start the timer
(see “Starting the timer”).
Multi-timer
 Tap on a different cooking zone

The additional cooking zone functions are displayed.

If the chosen cooking zone is not yet active (= power
level
0
) a power level can now be set.
 Tap the timer button

The time flashes in the 7-segment display above the
sliders in minutes (
0
0
0
).

Now the time can be set and the timer started
(see “Setting the time” and “Starting the timer”
respectively).
Switching the timer off early
 Tap a cooking zone with an active timer

The remaining time is displayed.
 Tap the timer button

The timer is switched off.

The system switches to the standard display.

The cooking zone remains active on the set power
level.
Time lapsed

10 seconds before the set time lapses, the system
flashes the remaining time.

In the last 5 seconds of the countdown an acoustic
signal can be heard every second.

The time display
0
0
0
and the timer button flash.

After the end of the set time the cooking zone is
automatically deactivated (= power level
0
).
7.5.7 Switching off the cooking zone
 Tap the required cooking zone.
 Swipe right down to the bottom until
0
appears in the
cooking zone display.
or
 Long press on the cooking zone

0
is displayed in the cooking zone display.

After 2 seconds, the standard display appears.
or
 Tap until
0
appears in the cooking zone display.