How to fix Bosch IP Access Controllers display if it is not working?
If the display on your Bosch IP Access Controller isn't working, it could be due to low voltage. Make sure the power supply provides enough voltage to power the controller. Also, check that the power is on.
What to do if there is no connection to BIS and AMS after a factory reset on Bosch IP Access Controllers?
If you have no connection to BIS and AMS after a factory reset on your Bosch IP Access Controllers, verify the controller is activated in the configuration settings.
Why is there no connection to BIS and AMS after factory reset of Bosch IP Access Controllers?
If there is no connection to BIS and AMS after a factory reset of your Bosch IP Access Controllers, it might be due to a connection issue with the access system. Check the configuration settings within the AMS or ACE system.
General| Model | Access Modular Controller 2 |
|---|---|
| Number of Doors Supported | 2 |
| Enclosure Rating | IP30 |
| Number of Outputs | 4 |
| Communication Protocol | TCP/IP |
| Connectivity | Ethernet |
| Current Consumption | 500 mA |
| Humidity | non-condensing |
| Number of Inputs | 8 |
| Compatibility | Bosch Access Management Software |
| Input Voltage | 12 to 24 VDC |
Provides a general overview of the Access Modular Controller 2's capabilities and features.
Details the components and layout of the main circuit board, including DIP switches and connectors.
Outlines how the controller connects to the host system and its overall architecture.
Instructions for attaching the controller to a standard 35 mm mounting rail securely.
Steps for safely removing the controller from its mounting rail.
Procedure for opening the controller's housing to access internal components.
Steps for properly reassembling the controller's housing after maintenance.
Guidelines and data for connecting cables, including power and data connections.
Procedures for grounding and shielding the controller to ensure electrical safety and signal integrity.
How to connect an external power supply to the controller using the pluggable screw connector.
Details on connecting the controller to a network via its Ethernet interface.
Information on configuring and connecting the controller using the RS-485 host interface.
Connecting additional I/O modules to the AMC2 using the RS-485 extension module bus.
Details on connecting card readers using the four RS-485 interfaces provided.
How to connect external devices to the controller's eight relay outputs.
Instructions for connecting devices to the controller's eight analog inputs.
Information on connecting external tamper contacts to protect the AMC2 from unauthorized access.
Steps for configuring the controller's Ethernet interface using the IPConfig tool.
Outlines the system requirements for UL compliance, including host systems and readers.
Explains the different UL 294 security levels relevant to access control products.
Detailed instructions for installing the system to meet UL requirements and restrictions.
Provides extended technical details, including specifications for RS-485 extension and power consumption.
Step-by-step guide to reset the controller's software using the reset button.
Procedure for resetting the entire device to its factory default settings, including network configuration.
Visual diagrams showing the physical connections for RS-485 and Ethernet interfaces on the PCB.
Information on the controller's status display, detailing various firmware versions and their output.
To Next Page
