Figure 7.20: Customer Information – Creating a new customer
There are two methods how to connect:
Automatic IP connection:
1. Select the Link index sheet.
2. Select the communication model Network Connect(UDP).
3. Click on the Connect button.
P The computer is connected to the AMAX panel.
Manual IP connection:
1. Select the Link index sheet.
2. Select the communication model Network Connect(UDP).
3. Click on the Wait for Incoming Call button.
4. Initiate IP connection from the AMAX panel via the keypad: Enter the subscriber number
and press [5] [7] + [#].
P The computer is connected to the AMAX panel.
Notice!
In case of a low transfer rate of the network or if a DX4020-G module is used, select the
option Specific network.
108 en | Configuration AMAX panel
2015.05 | 06 | F.01U.309.277 Installation Manual Bosch Sicherheitssysteme GmbH
To Next Page
Loading...
