Bosch AMAX 2100 - Page 147

Restore:
4 Restore the communication with DX4020 / ITS - DX4020G to a normal condition and reset
the fault. For more information, refer to DX4020-G, page 22.
Supervise:
1. Report the DX4020 / ITS - DX4020G fault to configured destination on address 124 when
the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
2. When the fault is reset, send the restored report to the configured destinations.
P The FAULT indicator is turned off, when there is no other system fault.
– Output Expansion Module 1-2 Failure
Condition:
No communication with DX3010 if DX3010 is available.
Restore:
4 Restore the communication with DX3010 to a normal condition and reset the fault. For
more information, refer to DX3010, page 18.
Supervise:
1. Report the DX3010 fault to configured destination on address 140 when the fault is
detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
2. When the fault is reset, send the restored report to the configured destinations.
P The FAULT indicator is turned off, when there is no other system fault.
– Input Expansion Module 1-6 Failure
Condition:
No communication with DX2010 if DX2010 is available.
Restore:
4 Restore the communication with DX2010 to a normal condition and reset the fault. For
more information, refer to DX2010, page 16.
Supervise:
1. Report the DX2010 fault to configured destination on address 140 when the fault is
detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
2. When the fault is reset, send the restored report to the configured destinations.
P The FAULT indicator is turned off, when there is no other system fault.
– Printer Failure
Module DX4010 Missing
Condition:
No communication with DX4010 if printer is available.
Restore:
4 Restore the communication with DX4010 to a normal condition and reset the fault.
Supervise:
1. Report the DX4010 missing fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators, page 8 for a detailed description).
2. When the fault is reset, send the restored report to the configured destinations.
P The FAULT indicator is turned off, when there is no other system fault.
Printer Missing
Condition:
AMAX panel
Troubleshooting | en 147
Bosch Sicherheitssysteme GmbH Installation Manual 2015.05 | 06 | F.01U.309.277