The following table shows how to program the numbers, keys, and functions for a subscriber
ID number via address programming or via installer menu programming.
Digit required Number to program via
address programming
Button to press via installer
menu programming
0 - 9 0 - 9 0 - 9
B 11 * 1
C 12 * 2
D 13 * 3
E 14 * 4
F 15 * 5
Receiver Transmission Format (Contact ID, SIA, Conettix IP)
Receiver 1 - 4 Transmission Format
When an event occurs, reports are sent to the central monitoring station via different
communication protocols using the transmission format CID or SIA.
The communication protocols contain various information on the events to be reported, for
example:
– event code
– alarm type
– subscriber ID / ID number 1 and 2 for account number 1 and 2 (4 digits for CID, 6 digits
for SIA)
– new event or previously reported
– zone number
– area number
– RRCFR (receiver number)
– LPREF (account prefix)
For reports with the AMAX panel, five kinds of communication protocols are available:
– Contact ID (default)
– SIA DC03
– Conettix IP
– SIA DC09
– SIA DC09 (2x ID)
Which communication protocols can be used in a particular case depends on the receiver of
the provider. Therefore, contact your provider.
The following table shows an overview of the available communication features for each
communication protocol.
36
en | Settings AMAX panel
2015.05 | 06 | F.01U.309.277 Installation Manual Bosch Sicherheitssysteme GmbH
To Next Page
Loading...
