Bosch B9512G - RPS > [1] RPS Passcode Menu Parameters

138 en | Keypad Installer menu Control Panels
2018.07 | 10 | F.01U.303.996 Installation Manual Bosch Security Systems, Inc.
Access Point Name
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [2] Cellular > (choose the SDI2 cellular
module or plug-in module) > [1] Access Point Name. The keypad shows the current
configuration.
3. Press Edit or Enter to edit the configuration.
4. Delete existing characters, if necessary, and then enter the new characters.
5. Press Save or Enter. The keypad shows Parameter saved.
Access Pt Username
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [2] Cellular > (choose the SDI2 cellular
module or plug-in module) > [2] Access Pt Username. The keypad shows the current
configuration.
3. Press Edit or Enter to edit the configuration.
4. Delete existing characters, if necessary, and then enter the new characters.
5. Press Save or Enter. The keypad shows Parameter saved.
Access Pt Passcode
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [2] Cellular > (choose the SDI2 cellular
module or plug-in module) > [3] Access Pt Password. The keypad shows the current
configuration.
3. Press Edit or Enter to edit the configuration.
4. Delete existing characters, if necessary, and then enter the new characters.
5. Press Save or Enter. The keypad shows Parameter saved.
SIM PIN
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [2] Cellular > (choose the SDI2 cellular
module or plug-in module) > [4] SIM PIN. The keypad shows the current configuration.
3. Press Edit or Enter to edit the configuration.
4. Delete existing characters, if necessary, and then enter the new characters.
5. Press Save or Enter. The keypad shows Parameter saved.
20.1.9 [3] RPS > [1] RPS Passcode menu parameters
The control panel verifies the remote programming software at the central station has valid
access before connecting using the RPS passcode. In this menu, you can program the RPS
passcode.
RPS Passcode
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [3] RPS > [1] RPS Passcode.
3. Press Edit or Enter to edit the RPS passcode.
4. Delete the existing number, if necessary, and enter the new number.
5. Press Save or Enter. The keypad shows Parameter saved.
6. Escape from the menu.