Control Panels Control panel installation | en 31
Bosch Security Systems, Inc. Installation Manual 2018.07 | 10 | F.01U.303.996
5 Control panel installation
Refer to Enclosures, page 111 to determine if the application requires a specific enclosure.
Enclosure and control panel (back view) overview
Callout á…³ Description Callout á…³ Description
1 á…³ Hooks to attach the mounting skirt (2) 5 á…³ Enclosure mounting holes (5)
2 á…³ Three-hole pattern for mounting modules (4) 6 á…³ Holes to attach the mounting skirt to hooks (2)
3 á…³ Mounting location for the tamper switch 7 á…³ Tab to secure the mounting skirt
4 á…³ Mounting skirt screw location
5.1 Installing the enclosure
Notice!
Electromagnetic interference (EMI)
EMI can cause problems on long wire runs.
1. Remove the knockouts.
2. Mount the enclosure. Use all enclosure mounting holes. Refer to the mounting
instructions supplied with the selected enclosure.
3. Pull the wires into the enclosure through the knockouts.
4. Position the supplied point label chart on the inside of the enclosure door (optional).
5.2 Installing the control panel
1. Position the control panel over the inside back of the enclosure.
2. Align the Holes to attach the mounting skirt to hooks with the hooks.
3. Slide the control panel down so that it hangs on the hooks.
4. Secure the mounting skirt screw.
To Next Page
Loading...
