90 en | Access control Control Panels
2018.07 | 10 | F.01U.303.996 Installation Manual Bosch Security Systems, Inc.
Notice!
The module reads the address switch setting only during module power up. If you change the
setting after you apply power to the module, you must cycle the power to the module in order
for the new setting to take effect.
SDI address settings
If multiple access control modules reside on the same system, each access control module
must have a unique address.
For valid addresses, refer to D9210C address settings, page 169.
Installation
For detailed instructions, refer to the corresponding document listed in Related
documentation, page 13.
15.3 Card reader wiring
To wire the access control module to a card reader, refer to the card reader instructions
printed on or shipped with the reader.
To Next Page
Loading...
