Bosch B9512G - Cellular Menu; IP Camera; Cloud

156 en | Keypad Installer menu Control Panels
2018.07 | 10 | F.01U.303.996 Installation Manual Bosch Security Systems, Inc.
2. Go to [3] Diagnostics Menu > [2] Network > (choose the bus module or on-board) > [2]
Connection.The keypad scrolls through the following sub-categories, indicating the
connection status for: Link, IP Address, DNS, LAN, WAN. (Use /Next to scroll through,
if necessary.)
3. When finished viewing the information, escape from the menu.
20.3.3 [3] Cellular menu
You can obtain certain cellular module diagnostic information using a keypad and this menu.
Cellular (diagnostics)
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [3] Diagnostics Menu > [3] Cellular > (choose the SDI2 cellular module or plug-in
module). The keypad scrolls through the following sub-categories, indicating the
diagnostic information. (Use /Next to scroll through, if necessary.)
– Link (Yes or No. Yes indicates a data connection to the carrier. No indicates a
connection problem.)
– IPv4 IP (The IP address of the cellular radio on the carrier’s network.)
– Base ID
– Signal (Signal strength = unacceptable, marginal, good, or very good.)
– Signal (In dBs.)
– Tel Num (If provided by the carrier.)
– ESN (The cellular radio electronic serial number.)
– Model (The cellular radio model.)
– Version (The cellular radio version.)
3. When finished viewing the information, escape from the menu.
20.3.4 [4] IP Camera
IP Camera
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [3] Diagnostics Menu > [4] IP Camera. The keypad shows one of the following
statuses:
– Not Configured
– Not Responding
– Bad Password
– Online
– Missing
3. When finished viewing the information, escape from the menu.
20.3.5 [5] Cloud
Cloud
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [3] Diagnostics Menu > [5] Cloud. The keypad shows the Cloud ID, which is also
on a label on the control panel.
3. Press /Next. The keypad shows the Cloud configuration, which is one of the following:
– Not Available
– Enabled on Ethernet
– Enabled on Cellular
– Enabled on Ethernet and Cellular