Bosch B9512G - Users Menu Parameters; Points Menu Parameters

144 en | Keypad Installer menu Control Panels
2018.07 | 10 | F.01U.303.996 Installation Manual Bosch Security Systems, Inc.
Press the icon or softkey for the desired scope.
-or-
Use Previous or Next to go to the desired scope.
9. Press Save or Enter. The keypad shows Parameter saved and then asks if you would like
to edit the area.
10. Press Edit or Enter to edit the type.
11. Depending on keypad model:
Press the icon or softkey for the desired area.
-or-
Use Previous or Next to go to the desired area.
12. Press Save or Enter. The keypad shows Parameter saved.
13. Escape from the menu.
20.1.15 [6] Users menu parameters
In this menu, you can change the Service User passcode and the passcode for User 1.
To add and remove users, change users passcodes, and perform other user functions from the
keypad, you must use the Users menu from the Main menu. Refer to the Control Panels
(B9512G/B8512G/B5512/B4512/B3512) Owner’s Manual for more information.
Users (In the Installer menu)
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [6] Users. The keypad shows the Installer passcode.
3. Use /Previous or /Next to toggle between user 000 (service user) and user 001 and
go to the user you want to edit.
4. Press Edit or Enter to edit the selected user. The curser flashes at the editing location.
5. Delete existing characters, if necessary, and then enter the new characters.
6. Press Save or Enter. The keypad shows Parameter saved.
7. Escape from the menu.
20.1.16 [7] Points menu parameters
Use the parameters in this menu to assign a Point Source and a Point Profile to each point.
The Point Source parameter assigns the point to a device (on-board, Octo-input, and wireless
are examples). The Point Profile determines how the point operates.
Point Source selections
Unassigned ZONEX
Octo-input Output
Wireless Keypad
On-board IP Camera*
POPEX Door
*The B426 and the “E” variants do not support IP cameras.
Point Profile selections
Assign a Point Profile to a point by selecting the Point Profile number. The tables below show the Point Profile
number and default configuration for each Point Profile. You must use RPS or the Installer Services Portal
programming tool (available in Europe, Middle East, Africa, and China) to configure the Point Profile parameters.