Bosch B9512G - Page 43

185 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Control Panels Power supply | en 43

Bosch Security Systems, Inc. Installation Manual 2018.07 | 10 | F.01U.303.996

1 ᅳ B520 Auxiliary Power Supply Module

2 ᅳ Battery 2 (BATT 2) - (12 V nominal lead acid)

3 ᅳ Battery 1 (BATT 1) - (12 V nominal lead acid)

Table of Contents

Default Chapter3
- Table of Contents3
Certifications, Approvals, Listings, and Safety9
- Listings and Approvals9
- Ulc9
- Security Industry Association (SIA)9
- Department of Defense (Dod)9
- Department of Energy9
- National Institute of Standards and Technology (NIST)9
- Federal Communications Commission (FCC) Rules10
- Industry Canada (IC)10
- Safety11
- Lightning11
- Earth Ground11
- Power12
Introduction13
- About Documentation13
- Related Documentation13
- Bosch Security Systems, Inc. Product Manufacturing Dates15
System Overview16
- Parts List16
- Control Panel Capacities16
- Features17
- SDI2 Interconnect Wiring17
- Points17
- Areas and Accounts17
- Digital Communication18
- Keypads18
- Events18
- Programming19
- Firmware Updates19
- Access Control19
- Ground Fault Detection19
- Dual Authentication19
- Recent Closing20
- Accessories20
- Compatible UL Listed Synchronization (Sync) Modules and Strobes25
Installation Checklist30
Control Panel Installation31
- Installing the Enclosure31
- Installing the Control Panel31
- Earth Ground32
- Ground Fault Detect Enable32
- Ground Fault Detection Troubleshooting32
- Control Panel to Module Wiring Overview33
Power Supply36
- Secondary (DC) Power36
- Install the Battery36
- Battery Status Led37
- Battery Maintenance38
- Battery Supervision38
- Battery Charging Circuit Float Charge38
- Battery Discharge and Recharge Schedule39
- B520 Aux Power Supply39
- SDI2 Address Settings40
- Supervision40
- Auxiliary Power Supply Trouble Conditions40
- Installation and Control Panel Wiring (B520)40
- Powered Device and Battery Wiring41
Telephone Communications44
- B430 Plug-In Communicator, Telephone44
- Supervision44
- Installation and Module Wiring (B430)44
- Diagnostic Leds45
- Phone Jack Location45
- Telephone Line Monitor46
- Called Party Disconnect46
- Communication Failure47
IP Communications48
- On-Board Ethernet Connection48
- Supervision48
- Local Programming48
- On-Board Ethernet Diagnostic Leds49
- Conettix Plug-In Cellular Modules50
- B426 Ethernet Communication Module50
- Address and Emulation Settings50
- Supervision50
- B426 Module Faults51
- Installation and Control Panel Wiring (B426)51
- Diagnostic Leds52
- Local Programming53
- B450 Conettix Plug-In Communicator Interface54
- SDI2 Address Settings54
- Supervision54
- Installation and Control Panel Wiring (B450)54
- Diagnostic Leds55
- Compatible Receivers for IP Communication56
Keypads, Keyswitches, Keyfobs and Transmitters58
- Keypads58
- Keypads Overview58
- B921C Two-Line Capacitive Keypad with Inputs59
- Shortcuts and Custom Functions59
- Address Settings60
- Supervision60
- Installation and Control Panel Wiring (Keypads)60
- Sensor Loops Overview and Wiring (B921C/B942/B942W Only)61
- Output Wiring (B942/B942W Only)62
- Troubleshooting62
- Keyswitches62
- Operation63
- Installation and Control Panel Wiring (Keyswitches)63
- RADION Keyfobs and Inovonics Pendant Transmitters64
On-Board Outputs65
- Circuit Protection65
- Total Available Power65
- Continuous Power Outputs66
- Programmable Power Outputs66
- Terminals 6 and 766
- Terminal 867
- USB Power67
Off-Board Outputs68
- B308 Octo-Output Module68
- SDI2 Address Settings68
- Supervision68
- Installation and Control Panel Wiring (B308)69
- B600 Retrofit ZONEX Module69
- Installation and Control Panel Wiring (B600)70
- D8129 Octo-Relay Module71
On-Board Points72
- Point Sensor Loops72
- Single EOL (and no EOL) Resistor Circuit Style72
- Dual EOL Resistor Circuit Style73
- Point Response Time74
Off-Board Points75
- B208 Octo-Input Module75
- SDI2 Address Settings75
- Supervision75
- Installation and Control Panel Wiring (B208)75
- Sensor Loops Overview and Wiring77
- B299 POPEX Module79
- SDI2 Address Settings79
- Supervision79
- Installation and Control Panel Wiring (B299)80
- POPIT Devices Overview and Wiring80
- B600 Retrofit ZONEX Module81
- Installation and Control Panel Wiring (B600)81
- D8125 Expansion82
- D8128D Octopopit Eight-Point Expander83
- Off-Board Points Test84
- Extra Point Events84
- Missing Point Conditions84
Wireless Modules85
- B810 Receiver85
- SDI2 Address Settings85
- Supervision85
- Installation and Control Panel Wiring (B810)85
- B820 SDI2 Inovonics Interface Module86
- SDI2 Address Settings86
- Supervision86
- Installation and Control Panel Wiring (B820)86
Access Control88
- B901 Door Controller88
- Address Settings88
- Supervision88
- Installation and Control Panel Wiring (B901)89
- D9210C Access Control Interface Module89
- Card Reader Wiring90
Program and Test the Control Panel91
- Program the Control Panel91
- Program the Control Panel with RPS91
- Program the Control Panel with the Installer Services Portal Programming Tool92
- Program the Control Panel with a Keypad92
- Walk Tests92
- Fire Walk Test92
- Intrusion Walk Test93
- Service Walk Test93
- Invisible Walk Test94
Control Panel Board Overview95
System Wiring Diagrams97
- Power Supply Side Wiring98
- Input Points Wiring with D125B, D130, or D12999
- Input Points Wiring with or Without EOL Resistors99
- SDI and ZONEX Wiring100
- SDI2 Devices General System Wiring102
- SDI2 Bus Wiring Recommendations102
- 2-Wire Smoke Wiring (D125B)104
Approved Applications106
- Optional Compatible Equipment106
- Burglar Applications106
- Bank Safe and Vault Applications106
- Fire Applications109
- Enclosures111
- Combination Fire and Intrusion Alarm Systems111
- Compatible UL Listed Components111
- Standby Battery Requirements and Calculations114
- Household Fire Warning Equipment117
- UL 365 - Police Station Connected Burglar Alarm Units and Systems118
- UL 636 - Holdup Alarm Units and System118
- Required Programming to Meet UL 864118
- Required Values to Achieve 180S (Ulc)/200S (UL) Supervision Interval122
- Ulc122
Keypad Installer Menu123
- Program Menu (Programming)130
- Reporting > [1] Phone Menu Parameters130
- Reporting > [2] Network Menu Parameters131
- Reporting > [3] Routing Menu Parameters132
- Reporting > [4] Personal Note Menu Parameters133
- Network > [1] Ethernet > (Choose the Bus Module or On-Board) > [1] Module135
- Network > [1] Ethernet > (Choose the Bus Module or On-Board) > [2] Address136
- Network > [1] Ethernet > (Choose the Bus Module or On-Board) > [3] DNS137
- Network > [2] Cellular > (Choose the SDI2 Cellular Module or Plug-In Module)137
- RPS > [1] RPS Passcode Menu Parameters138
- RPS > [2] RPS Phone Number Menu Parameters139
- RPS > [3] RPS IP Address Menu Parameters139
- RPS > [4] RPS Port Number Menu Parameters139
- Area Options Menu Parameters140
- Keypad Menu Parameters141
- Users Menu Parameters144
- Points Menu Parameters144
- Disable Programming Menu152
- Wireless Menu152
- RF Point Menu> [1] Enroll Point RFID152
- RF Point Menu> [2] Replace Point RFID153
- RF Point Menu> [3] Remove Point RFID153
- RF Repeater Menu > [1] Add Repeater153
- RF Repeater Menu > [2] Replace Repeater154
- RF Repeater Menu > [3] Remove Repeater154
- RF Diagnostic Menu > [1] RF Points154
- RF Diagnostic Menu > [2] RF Repeater Menu155
- Diags Menu155
- Wireless155
- Network Menu155
- Cellular Menu156
- IP Camera156
- Cloud156
- Service Bypass (Serv Byp) Menu157
- Versions Menu157
- Cloud Menu158
- USB Power158
Specifications159
- Wire Requirements160
Appendix163
- Address Settings163
- B208 Address Settings163
- B299 Address Settings165
- B308 Address Settings165
- D8128D Address Settings167
- D8129 Address Settings168
- B901 Address Settings168
- B91X Address Settings168
- D9210C Address Settings169
- SDI Keypad Address Settings170
- Reporting and Device Number Information171
- Report Format Definitions171
- Device Numbers (Zzz, DDDD)180
- Communication Trouble Device Numbers (Zzzz)181
- Special User Ids (Uuuu, IIII)181
- Keypad Alarm Virtual Point Numbers (Ppp, Pppp)182
- Autoip182

Other manuals for Bosch B9512G

Operation Manual224 pages

Program Entry Guide284 pages

Installation And System Reference Guide186 pages

Owner's Manual228 pages

Quick User Guide56 pages

Quick Start Guide2 pages

Related product manuals

Preview: Bosch B9512G-E

Preview: Bosch B5512

Preview: Bosch B6512

Preview: Bosch B8512G

Preview: Bosch MPC-xxxx-B

Bosch MPC-xxxx-B

Preview: Bosch D7412G

Preview: Bosch FPA-5000

Preview: Bosch FPD-7024

Preview: Bosch ICP-CC488

Bosch ICP-CC488

Preview: Bosch 2000 Series

Bosch 2000 Series