23
4.9 Adjustment functions
4.10 Reset
4.11 Error inquiry
i Make sure that the Service switch is
set to On
before you open the Setting
functions menu.
For details on how to adjust the exhaust-
gas analyzer module and undertake
country-specific settings, please refer to
Section 4.5.1 (country-specific settings).
Return to the function menu by clicking
Back or by pressing keys Alt + B.
A reset must be performed when entries
have been modified in the Setting
functions menu. These modified
settings will only be stored in the
flashprom of the exhaust-gas analyzer
module after a reset.
Select Yes by clicking it or with the tab
key . Confirm that you wish to perform
a reset with E or by double-clicking the
mouse.
The fault memory is deleted and the
exhaust-gas analyzer module is restarted.
i For approx. 15 s, the exhaust-gas
analyzer module has no connection to
the laptop or PC.
The following message therefore appears:
The measuring device reported hardware
failure!
The error code must be read!
After 15 s, restart the Service program
with E or by clicking OK.
Any current faults in the exhaust-gas
analyzer module are displayed in plain
text.
Confirm the readout of the fault memory
with E or by clicking OK. The fault
memory is deleted and the screen returns
to the Function menu.
i If a fault still remains in the exhaust-
gas analyzer, this will be displayed
again.
To Next Page
Loading...
