Ethernet Job Listing
9--2
1070 072 196-101 (00.06) GB
Job Listing
Job listing is switched on and off with the T-button.
During switch-on and switch-off, error listing, too, is switched on and off with
the T-button. If job listing is enabled, the middle segment at the upper seg-
ment display is activated.
Error Listing
Error listing is switched on and off with the E-button.
Error listing can only be switched on if job listing is switched off. If error listing
is enabled, the lower segment at the upper segment display is activated.
Message Data Output
With job listing, only client and server commands are output. In addition, the
O-button is used for switching on and off the output of the message data.
The message data output is only effective if job listing is switched on.
List of Communicating Stations
Via the K- or the C-button, the list of communicating stations is output. This
list contains the assignment of the Ethernet address to the IP address.
In addition, the list of communicating stations contains information about
whether the list entry is free or reserved and for how long the entry is still go-
ing to be valid. The timer is set to the value of the retransmission timer by
client jobs.
If an external communication station uses a password, ’attached’ is dis-
played.
Example:
act. Serverlist
Ethadr: 00-60-34-00-08-1F IP-Adr: 142.2.26.144 Timer: 0 static
Ethadr: 00-60-34-00-08-0B IP-Adr: 142.2.26.146 Timer: 0 static attached
Ethadr: 00-60-34-00-08-0A IP-Adr: 142.2.26.145 Timer: 0 static
Ethadr: AA-00-04-00-02-40 IP-Adr: 142.2.1.100 Timer: 52 used attached
Ethadr: 00-00-0C-4E-58-0D IP-Adr: 142.2.1.102 Timer: 59 used
...
This list also shows the static part of the ARP table which is preset by the
configuration file.
To Next Page
Loading...
