HDD info
Figure 7.13: HDD info
This top of the screen provides information on the current status of each HDD (O means
current HDD is normal; X means there is a disk error; – means there is no HDD; ? means disk
is damaged). After a system start, the system will first check for any HDD error. If an error (X)
is shown:
1. Check the hard disk time and system time are the same (if necessary, modify system time
in Setting > General and reboot the system).
2. If the error persists, format the HDD and reboot the system.
Earliest recording – shows the date and time of the oldest recording still available on the
HDD.
Total protected size – shows the total size of all protected recordings stored on the HDD (you
can protect a recording using the Protect Playback function available on the Search/Play
screen).
The bottom half of the screen lists each HDD type, total size, and the free space remaining on
the disk. Double-click on any item for more (Smart) information – see following example.
7.4.1
DIVAR AN 3000 / DIVAR AN 5000 Operating instructions | en 105
Bosch Security Systems Operations Manual 2014.10 | 2.0 | AM18-Q0669
To Next Page
Loading...
