26 en | Product Description Modular Fire Panel
F.01U.028.089 | 5.4 | 2009.08 Product Information Bosch Sicherheitssysteme GmbH
When a 10 A flat tab fuse is fitted into base connection 2-3, the next two NAC lines (NAC3 and
NAC4) are also supplied with power from the power supply unit connected to PS2. The flat
tab fuses are used as jumpers here. The same applies to the other three connection bases.
Technical specifications
1.10.5 RLE 0000 A Junction Board EU
This junction board is designed to be installed in the CPH 0006 A and MPH 0010 A Modular
Panel Housing, Frame Installation, and is also needed to connect the AT2000 transmission
device.
1.10.6 RLU 0000 A Junction Board US
This junction board has been specially developed for the HCP 0006 A and HBC 0010 A
Modular Panel Housings.
1.10.7 HMP 0001 A Mounting Plate Short
Fuses 2 x 25 A
5 x 10 A
Connections - 10 plug connections, 4-pin, for 10 notification appliance
circuit lines
- 2 plug connections, 2-pin, for connecting the HPD to the
BCM Battery Controller Module
- 5 plug connections, 2-pin, for connecting other power supply
units to the notification appliance circuit lines
- 3 pairs of tab terminals for battery connection
Safety standards IEC 60950 / EN 60950
Permissible operating
temperature
-5 °C to 50 °C (23 °F to 122 °F)
Permissible storage
temperature
-20 °C to 60 °C (-4 °F to 140 °F)
Color (PC board) Light green
Dimensions (H x W x D) Approx. 100 x 160 x 29 mm (3.9 x 6.3 x 1.1 inches)
Weight Approx. 100 g (approx. 3.5 ounces)
To Next Page
Loading...
