40 en | Product Description Modular Fire Panel
F.01U.028.089 | 5.4 | 2009.08 Product Information Bosch Sicherheitssysteme GmbH
1.15.4 ENO 0000 B Fire Service Interface Module
The ENO 0000 B is used to connect fire service equipment:
– Transmission unit to fire department
– Key deposit
– Signal lamp (e.g. BEGA flush-mounting lamp or BL 200)
– Monitoring a release device
– Four freely programmable change-over relays
Technical specifications
NOTICE!
The requirements of the local fire department must be followed when programming the
module!
Labeling Connector
AGround
B Transmission unit control
C Feedback contact
Transmission unit Automatic dialer and transmission unit fault
NQuit Acknowledge
GND Ground
ÜE+ / ÜE- Power supply of transmission unit
1 Monitoring key deposit
2Ground
5 Door release magnet, + 12 V/24 V, approx. 10 W
8 Key deposit lock monitoring
6/7 Ground
9 Heating, +24 V, approx. 0.8 W
10 Ground
FSE+ / − Monitoring of the release device
⊗ + / − Signal lamp, e.g. BEGA lamp +24 V, approx. 10 W
Relays 1-4
Display and operating elements 2 LEDs (1 x red, 1 x yellow)/1 button (LED test)
Input voltage 20 V DC to 30 V DC
Current consumption
- In standby 25 mA
- All relays triggered 60 mA
- Key deposit heating Additional 240 mA
Permissible relay contact load 1 A/30 V
Dimensions (H x W x D) Approx. 127 x 96 x 60 mm (5.0 x 3.8 x 2.4 inches)
Weight Approx. 150 g
To Next Page
Loading...
