A
If in doubt, look it up
111
Menu items on the display
The
menu items from which you can select the next operating step will appear on
the display depending on the function you are currently performing. This overview
contains an alphabetic list of the most important menu items.
If you want to answer an additional call.
T
o store an entry from the main telephone book in your private telephone
book.
The AEI interface on the bottom of the telephone can be used to connect
accessories, e.g. a headset. If an additional device is connected to your
phone, you can configure the AEI protocol using this function.
Y
ou can connect various supplementary equipment, such as a headset, a
DSS module or a PC, to the AEI interface on the bottom of your phone. De
-
pending on the configuration used, you have to set one of the three operat
-
ing modes.
A
T command:
With this mode of operation your telephone acts like a mo
-
dem which can be controlled by means of A
T commands. Here, only the
telephone
is controlled. Not data is transmitted to the the remote subscriber
.
There are three additional options to do the settings for the baud rate, data
bits and parity
.
Y ETSI A
T modem:
Y
ou can connect a PC to the AEI interface at the bot
-
tom of your telephone. T
o do this, you have to set the AEI operating mode
to ”Y ETSI A
T“.
Y
ou can then perform the functions of your telephone on the PC using PTM
(”Personal T
elephone Manager“, a Windows program). These functions are:
setting the telephone, editing phone book entries, writing texts for notes or
phone book entries and saving data on the PC. If you have connected a PC
to the AEI interface, you can see if a call had been diverted or transferred
from another connection. The PC shows you, therefore, to which call num
-
ber a connection really exists.
X FTZ A
T modem:
The operating mode corresponds to the definition of the
X interface of the FTZ as used for the first generation of ISDN PSTN line
telephones. Using this protocol the AEI interface is compatible with PC ap
-
plications, especially ISDN cards, which require the X interface.
Adjust the volume of the special information tone.
Accept
call
Accept entry
AEI
AEI operation Y ETSI AT
Alerting
To Next Page
Loading...
