Bosch Integral TM13 - Terminal Adapter Operations

If in doubt, look it up
137
Terminal adapter -
You can use the built-in terminal adapter to set up data connections to compatible
data terminals via the V.24 interface. Y ou must first define the transmission parame -
ters. Y
ou can also make calls simultaneously depending on the connection to your
telephone system.
Setting up data connections
Y ou can set up a data connection manually
from the keypad of your telephone or by
means of data terminal dialing.
Set up via your phone:
Select the menu item “T A dialing”. Y ou can
use this function to set up a data connec
-
tion via the keypad on your telephone.
Y ou may now enter the call number of your
communication partner
.
Enter the desired number . If you wish to
store the data transmission numbers under
destination keys, you must define these
numbers as “Data destinations” in the tele -
phone book ( → p. 60).
Select the menu item “Dial”. The call num -
ber is dialed and you can begin data trans -
mission.
Making normal calls in between:
Select the menu item “T A dialing”.
This allows you to alternately display in -
formation about your call or data connec -
tion.
Note:
The display message “on” indicates that
the data connection exists. If you store the
“T A dialing” function on a function key , you
can switch the call mode by means of a
single keystroke.
Setup via your data terminal:
Y ou can set up a data connection via your
data terminal. Specify the corresponding
dialing method. Further information may be
found in the user manual of the terminal
adapter.
Menu 'TA dialing µ
TA 1234 ↓
Menu ' TA dialing µ