If in doubt, look it up
116
Menu
items on the display
The displayed number is dialed.
Configuring the terminal adapter: V
arious settings facilitate the set up of
incoming and outgoing or just incoming calls.
Manual:
Asynchronous only
. To support simple terminals. Y
ou can enter the call
number using the terminal keyboard.
A
T command:
Asynchronous only
. For automatic call control by means of A
T commands
from the terminal.
Hotline 108:
For applications with dedicated lines. The target address is taken from the
telephone book of your telephone.
Incoming:
For automatic call setup. Only incoming calls are possible.
Direct dialing: Dialing begins as soon as you press a destination key
.
Direct dialing: Dialing begins as soon as you press a digit key
.
Deactivate charge recording for chargeable calls.
DTR: For call setup by your terminal. At the same time the function “DTR
contr
.” must be active. Otherwise, the call can only be cleared down by the
remote subscriber or by your telephone.
If you disable the call number display
, the number of the person you are
talking to is no longer displayed on your telephone. Moreover
, the number
is not stored in the redial memory. Redisplay number: Select menu item
again.
Tests the display
. Each display remains on the screen for 5 seconds.
Dial
Dial
Direct
dial:dest
Direct dial:digit
Disable charges
Disconnect
Display
Display
To Next Page
Loading...
