Bosch MAP 5000 Series - Table of Contents

MAP 5000 Table of contents | en 3
Bosch Security Systems B.V. Installation manual 2019-09 | 25 | F.01U.168.332
Table of contents
1
Introduction 5
1.1 Short information 5
1.2 Listings and approvals 5
1.3 Battery handling 5
1.4 Installation considerations 5
1.5 Planning the system 6
1.5.1 Planning the system with IPP-MAP0005 power supply 7
1.5.2 Planning the system with ICP-MAP0012 CAN splitter module 11
1.6 System overview 12
2
Installation 15
2.1 Removing the enclosure knockouts 15
2.2 Installing the tamper switch rail 16
2.3 Mounting the enclosure 17
2.4 Checking the AC connection 19
2.5 Installing the power supply and power supply accessories 19
2.6 Installing the TAE box 23
2.7 Installing the accessory mounting plate 24
2.8 Installing the 12 V converter 26
2.9 Installing the fuse plate (SIV) 27
2.10 Installing the AT 2000 communicator 28
2.11 Installing the hinged mounting plate 33
2.12 Mounting the main panel 36
2.13 Installing the ICP-COM-IF relay module 37
2.14 Installing and connecting the ITS-MAP0008 wireless modem 38
2.15 Antennas 40
3
Connections 41
3.1 Connecting the data bus 41
3.1.1 Internal / external data bus 43
3.1.2 Topology of the external data bus 43
3.1.3 Splitting the external data bus with a CAN splitter module 44
3.2 Connecting the control center 44
3.3 Connecting the main panel 45
3.4 Connecting the power supply 46
3.5 Connecting the LSN gateway 47
3.6 Optional connections 49
3.7 Installing and connecting the tamper switch 51
3.8 Installing the ICP-MAP0060 enclosure lockset 53
3.9 Installing the control center 55
3.10 Final power connections 55
3.11 IP Interface 56
4
Initial set-up and programming 57
4.1 Initial set-up 57
4.2 Programming 57
4.2.1 Help for the programming software 58
4.2.2 Standard-compliant programming 58
4.3 Panel software 58
4.3.1 Checking the software version 58
4.3.2 Software updates 59