60 en | Initial set-up and programming MAP 5000
2019-09 | 25 | F.01U.168.332 Installation manual Bosch Security Systems B.V.
Bolt contact No No
1
No Yes
Trouble Yes No
1
Yes Yes
Technical Yes No
1
Yes No
Fire Yes No
1
Yes No
1
Assignment to Internal Program not possible or with no effect
4.6 Output functions
4.6.1 Programmable output signals
The following functions can be programmed at outputs.
p = programmable
Behavior item type Output is activated for …
Hold-up alarm Hold-up (silent)
Hold-up (non silent)
Amok alarm Amok alarm (silent)
Amok alarm (non-silent)
Duress alarm Duress alarm
External intrusion alarm Intrusion alarm from unoccupied protection area
Internal intrusion alarm Intrusion alarm from disarmed area with
– activated internal program
– intrusion alarm 24h
Technical alarm Technical alarm
External system trouble Power supply failure (p), battery trouble
Internal system trouble Power supply failure, ground fault, printer trouble
External intrusion trouble Detector self test trouble
Internal intrusion trouble Anti-mask trouble
Technical trouble Technical trouble
Summary area armed One or more areas armed externally
Area armed Area x armed externally
Area disarmed Area x disarmed externally
Area ready to arm Area x disarmed and ready to arm
Internal program ON Internal program x switched on
Chime Detector has tripped chime, only if chime mode is
activated
Monitor (output follows Input) Shows the actual status of the input: normal / active
Report failure panel alarm
(V1.2x)
Panel has received negative acknowledgment from
communicator as a result of report failure panel alarm
(only for panel firmware 1.2.x)
To Next Page
Loading...
