Bosch MAP 5000 Series - 2.13 Installing the ICP-COM-IF Relay Module

MAP 5000 Installation | en 37
Bosch Security Systems B.V. Installation manual 2019-09 | 25 | F.01U.168.332
2. Position the ferrite core as close as possible to the enclosure knockout inside the
enclosure.
Ferrite core
2.13 Installing the ICP-COM-IF relay module
The ICP-COM-IF relay module can be mounted on the hinged mounting plate or the mounting
rails of the MAP control panel enclosure.
A clearance of approx. 15mm is required on either side for subsequent wiring. The terminal
plugs can be unplugged laterally.
1. Attach the carrier plate of the ICP-COM-IF relay module in the holes provided in the
hinged mounting plate or the mounting rails.
2. Use the screw provided to secure the carrier plate to the bottom rail.