Bosch OBD 1350 - MIL Status

en
|
28
|
User guide
| OBD 1350
ProGrade OBDII Scan Tool
580001 | REV. A | 11.2016
1. Select Erase Codes.
• Use the UP and DOWN keys until Erase
Codes is highlighted.
• Press .
Diagnostic Codes
Read Codes
Erase Codes
View Freeze Data
Component Locator
Acronyms
Review Data
Print Data
Code Lookup
System Setup
• If diagnostic results and codes are not to be
erased select NO and press .
Erase Codes
Are you sure you want to
erase diagnostic results and
codes?
No
Yes
• Selecting NO displays a “Command canceled”
message.
Erase Codes
Press ENTER to continue
Command canceled
2. Select YES to erase diagnostic results and codes.
• Use the LEFT arrow key.
• Press .
Erase Codes
Are you sure you want to
erase diagnostic results and
codes?
No
Yes
3. If more than one module is supported, a menu is
displayed.
• Use the UP and DOWN keys until the
desired choice is highlighted.
• Press .
Select Module
OBDII/EOBD
Engine
ABS
Airbag
4. Observe “Command sent” message is displayed.
• Press .
Erase Codes
Press ENTER to continue
Command sent
Codes remaining:0
5. Return to Diagnostic Codes Menu.
• Press .
5.4 MIL Status
From Global OBDII Functions Menu:
1. Select MIL Status.
• Use the UP and DOWN keys until MIL
Status is highlighted.
• Press .
Global OBDII Functions
I/M Monitors
Drive Cycle Monitor
State OBD Check
MIL Status
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Vehicle Information
Oil Light Reset
2. View MIL Status.
• Press to return to Global OBDII Functions
Menu.