Bosch Rexroth CS 440RC - Conveyor Speed Sensor Setup; Setting Conveyor Pulses per Revolution

23/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
6 Conveyor Speed Sensor Configuration
The calibration of the system configures the controller for the KG or LBS of material
discharging from the conveyor for every revolution of the conveyor speed sensor. As
the sensor transmits pulses, the controller needs to know how many pulses per
revolution are generated.
6.1 Setting the Pulses per Revolution
The pulses per revolutions generated by the conveyor speed sensor vary depending
on the make of hydraulic motor. The most common hydraulic motor makes and
matching pulses per revolution are as follows:
Pulses per Revolution
Pulses per RevolutionPulses per Revolution
Pulses per Revolution
Standard externally mounted sensor
White Hydraulic Motor
Parker Hydraulic Motor
Char-Lynn Hydraulic Motor
16
50
30
40
Insert the programming key, select “SENSORS AND VALVES”, and select
“CONVEYOR SETUP”. The screen to the left will appear.
Use the Up or Down navigation buttons move the cursor to ‘CONVEYOR SENSOR”
and press the Enter button. The screen on the left will appear.
Press the Enter button to enter the “XX” Pulses per Rev.
Use the Right or Left navigation button to move the cursor under the number to be
changed.
Use the Up or Down navigation buttons to change the number as required to suit
the Pulses per Rev. for the appropriate hydraulic motor.
Once all the numbers have been changed, press the Enter button.
Press the Escape button three times to return to the first screen.