33/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
10 Pre-wetting System
10.1 Selecting the Pre-wetting System’s “Mode of Operation”
Insert the programming key, select “SYSTEM SETUP” and select “PREWET MODE”.
The screen to the left will appear.
Off
OffOff
Off
The pre-wetting system is not activated.
Fixed Pre
Fixed PreFixed Pre
Fixed Pre-
--
-wet
wet wet
wet (F)
(F)(F)
(F)
The pre-wet rate is a calibrated fixed rate, the pre-wetting system is operated by the
conveyor motor exhaust oil.
Clos
ClosClos
Closed L
ed Led L
ed Loop
oop oop
oop –
––
–
pulses/rev.
pulses/rev.pulses/rev.
pulses/rev.
The pre-wetting system has a hydraulic motor speed sensor, which is used for input
to control the pre – wetting rate.
Closed f
Closed fClosed f
Closed flow/min
low/min low/min
low/min (V)
(V)(V)
(V)
The pre-wetting system has a flow meter, which is used for input to control the pre–
wetting rate.
Manual
Manual Manual
Manual (M)
(M)(M)
(M)
The pre-wetting system is set to manual mode.
Return Oil Pre
Return Oil PreReturn Oil Pre
Return Oil Pre-
--
-wet
wet wet
wet (S)
(S)(S)
(S)
The pre-wet rate is a variable rate system, the pre-wetting system is operated by the
conveyor motor exhaust oil.
• Using the navigation buttons, move the cursor to the desired option and press
the Enter button. The screen will return to the previous screen.
• Press the Escape button twice to return to the first screen.
10.2 Selecting the “Solid Reduction” Rate When Liquid is Applied
Insert the programming key, select “SYSTEM SETUP” select “OPERATION
SETTINGS” and select “SOLID REDUCTION”. The screen to the left will appear.
• Using the Up or Down navigation button, move the cursor in front of the
material to be reduced and press Enter.
• Using the Left or Right navigation button, move to number to be changed.
• Using the Up or Down navigation button, change the number as required.
• Once all the numbers have been changed, press the Enter button.
• Press the Escape button three times to return to the first screen.
To Next Page
Loading...
