9/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
2 Configuring and Setting up the CS-440RC
2.1 How to Configure the CS-440RC
The manual is broken down into the various components that make up a system,
when troubleshooting a section of the system go directly to the page covering that
particular section. (See Table of Contents.)
The following instructions apply to all of the sections making up a system, becoming
familiar with these steps will allow you to Configure and Set-up any individual
section.
To set up the CS-440RC a programming key is needed, this is to prevent
unauthorized personnel from making adjustments. Make sure only authorized staff
has access to the key.
Insert the key and turn same ¼ turn and the screen to the left will appear.
Using the navigation button move the cursor to the area to be configured and press
the Enter button.
Place the cursor in front of “SYSTEM” and press the Enter button. The screen to the
left will appear.
Each of these sections can be configured from this screen, refer to the Table of
Contents for the proper page number and instruction for each section.
To return to the first screen, press the Escape button.
To Next Page
Loading...
