Bosch Rexroth CS 440RC - Error Message Configuration; Understanding Operational Errors; Inputs and Outputs Error Explanations

47/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
16 Error Message Configuration
16.1 Operational Errors
Insert the programming key, select “ERROR CONFIG”, and select “OPERATION”. The
screen to the left will appear.
The operational errors cannot be changed; these are all by factory default. The only
variable allowing changes are the TIME and ACTION for each error message. See
section below.
Error Message
Error MessageError Message
Error Message
Description
DescriptionDescription
Description
UNDER APPLICATION
The controller can
not p
roduce the desired solid out
put.
Possible
caused are:
• Wrong gate setting
• Low Engine RPM
• Hydraulic pump wear
• High speed
LIQUID UNDER APP
Same as above for the liquid output
.
KNOBS NON ZERO
Application buttons are
not at zero and equipment could start
without warning.
BLAST TOO LON
G
The Blast mode exceeded its time limit
.
OVERSPEED
Vehicle
speed exceeded the preset limit
CALIBRATION
The setting desired can
n
ot be produced, check settings.
16.2 Inputs and Outputs Errors
Insert the programming key, select “ERROR CONFIG”, and select “INPUTS AND
OUTPUTS”. The screen to the left will appear.
Error Message
Error MessageError Message
Error Message
Description
DescriptionDescription
Description
KNOB INPUT FAILURE
The spinner, Conveyor or pre
-
wet application rate
buttons are not functioning.
VALVE OUTPUT ERROR
The Controller output to the valves has failed
.
MC08 SYSTEM FAILURE
The system mobile controller (MC08) has failed
.
NO MATERIAL
This error indicates there is no material on the
conveyor (optional).
NO GROUND SPEED
INPUT
The controller is not receiving a signal from the
ground speed sensor.
NO C
ONVEYOR SENSOR
OUTPUT
The controller is not receiving a signal from the
conveyor speed sensor.