Bosch Rexroth CS 440RC - Configuring System for Multi Boom Anti-icing; Changing Liquid 3 to Read ANTI-I (Multi Boom); Entering Anti-icing Liquid Rates (Multi Boom)

40/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
11.2.2
11.2.2 11.2.2
11.2.2 Set
SetSet
Setting the System for Multiple Boom Anti
ting the System for Multiple Boom Antiting the System for Multiple Boom Anti
ting the System for Multiple Boom Anti-
--
-icing
icingicing
icing
Using the navigation buttons, move the cursor to “MATERIAL SETUP”, select
“PREWET 3” and press the Enter button. The screen to the left will appear.
11.2.3
11.2.3 11.2.3
11.2.3 Change LIQUID3 to Read ANTI
Change LIQUID3 to Read ANTIChange LIQUID3 to Read ANTI
Change LIQUID3 to Read ANTI-
--
-I
II
I
• Press Enter and using the Left or Right navigation button, move to letter to be
changed.
• Using the Up or Down navigation button, change the letter as required.
• Once all the letters have been changed, press the Enter button.
11.2.4
11.2.4 11.2.4
11.2.4 Entering the Anti
Entering the AntiEntering the Anti
Entering the Anti-
--
-icing Liquid Rates
icing Liquid Ratesicing Liquid Rates
icing Liquid Rates
• The screen rates are in ltr or gal per ton, treat this as ltr/km or gal/mile.
• Move the cursor to the first line of rates and press Enter.
• Using the Left or Right navigation button, move to number to be changed.
• Using the Up or Down navigation button, change the number as required.
• Once all the numbers have been changed, press the Enter button.
Calibrate this liquid as per calibration procedure under “PREWETTING AUTO
CALIBRATION”.
Press the Escape button twice to return to the first screen.