Bosch Rexroth CS 440RC - Setting Spinner Maximum RPM; Setting Spinner PPS Factor; Spinner Calibration in gm;mm2 Mode

32/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
9.5
9.59.5
9.5.3
.3.3
.3 Setting the Spinner
Setting the SpinnerSetting the Spinner
Setting the Spinner’s PPS Factor
’s PPS Factor’s PPS Factor
’s PPS Factor
Insert the programming key, select “SENSORS AND VALVES”, select “SPINNER
SETUP” and select “VALVE SETTING”. The screen to the left will appear.
• Determine the system’s PPS Factor - Spinner RPM / Maximum Spreading
Speed.
• Use the Down navigation button to move the cursor in front of “11 – PPS
Factor” and press the Enter button.
• Using the Left or Right navigation button move to the number to be changed.
• Using the Up or Down navigation button, change the number as required.
• Once all the numbers have been changed, press the Enter button.
• Press the Escape button three times to return to the first screen.
9.6 Spinner Calibration in the “gm/mm2” Mode
Insert the programming key, select “SENSORS AND VALVES”, select “SPINNER
SETUP” and select “WIDTH CALIBRATION”. The screen to the left will appear.