Bosch Rexroth CS 440RC - Presetting Pre-wet Selection Options; Configuring General Operator Options; Resetting the Season Total Data

44/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
13.3 Presetting the Pre-wet Selection
Insert the programming key, select “SYSTEM SETUP”, select “OPERATION
SETTINGS” and select “PREWET SELECT”. The screen to the left will appear.
Use the Down navigation button to move the cursor to “DESIRED LIQUID” and press
the Enter button.
Press the Escape button twice to return to the first screen .
13.4 Setting the Operator Options
Insert the programming key, select “SYSTEM SETUP”, select “OPERATION
SETTINGS” and select “OPERATOR OPTIONS”. The screen to the left will appear.
Note: MODE is the mode of operation for the liquid system.
Use the Down navigation button to move the cursor to “DESIRED OPTION” and
press the Enter button.
Press the Escape button twice to return to the first screen.
13.5 Resetting Season Total
To clear the season total RIGHT, LEFT, and Enter buttons need to be pressed and
let go at the same time.