Bosch Rexroth CS 440RC - Frequently Asked Questions (FAQs); CS-440 RC Controller FAQs; Interpreting Log Data Report Headers

50/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
17 Frequently Asked Questions (FAQs)
17.1 CS-440RC
1.
1.1.
1. What do those Headers in log data reports mean?
What do those Headers in log data reports mean? What do those Headers in log data reports mean?
What do those Headers in log data reports mean?
Headers
HeadersHeaders
Headers
Meaning
MeaningMeaning
Meaning
Date and Time This is the absolute time, at the start of the event
Event Type This is the cause of the event, as follows:
• STAT - System-Generated event, send the database to Compu-
Spread for diagnosis
• INIT - rebooted the controller
• RATE - Application Rate change, solid or liquid
• GATE - Gate Position change
• 6HRS - Duration of event is 6 hours
• DEIC - Deice-simulation turned on or off
• ERR - Error occurred
• CTRL - Change in control mode for conveyor
• MATL - Change of solid or liquid material
• GSLP - gate or solid or liquid change when leaving PROGRAM
mode
• CTUP - control mode or system units change leaving PROGRAM
mode
• SPIN - Spin Rate change when in g/m**2 mode
Solid Rate
Normally kg/km
PreWet Rate
Normally liter/tonne
Boom Status
LCR to indicate whether le
ft, centre, or right boom is on
Ground
Speed
Calculated speed, based on Total Time and Total Distance
Total Time
Total Tim
e of duration of this event, including blasting and pausing
Blast Time
Total time of blasting during this event
Pause Time
Total time of pausing during this event
Total Dist.
Total distance travelled during this event, including blasting and p
ausing
Blast Dist.
Total distance travelled while blasting
Pause Dist.
Total d
istance travelled while pausing
Total Solid
T
otal solid delivered during this event, including blasting and pausing
Blast Solid
Total solid delivered w
hile blasting
Blast Number
Number of times the Blast button was pushed
Total PreWet
Total pre
-
wet delivered during this event, including blasting and pausing