49/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
Use the Down navigation button to move the cursor to the desired error function
and press the Enter button. The screen to the left will appear.
Use the Down navigation button to move the cursor to “ACTION” and press the
Enter button. The screen to the left will appear.
Error Message
Error MessageError Message
Error Message
Description
DescriptionDescription
Description
bled from the system and is not f
TAKE NO ACTION
a warning or reminder only and
to be taken.
LOOP
The system will continue to function
application rates are now a percentage of the maximum conveyor speed
but the system still responds to ground speed input.
The system will continue to function in the Manual Mode, the
application rates are now a percentage of the maximum conveyor
speed, neither ground speed nor conveyor speed input are available.
All outputs to the valves are frozen and the system will be operating.
Outputs return to normal control once the operator acknowledges the
alarm.
All outputs go to zero when the error is activated and will remain at
zero once the operator acknowledges the alarm. The application rate
button will no longer function.
As above for the liquid only
MANUAL
The liquid system will continue to function in the Manual Mode, the
application rates are now a percentage of the maximum pump speed,
neither ground speed nor flow meter input is available.
Using the navigation buttons, move the cursor to the desired option and press the
Enter button. The screen will return to the previous screen. Repeat the same for
each error function.
Once all the error functions have been configured, press the Escape button once,
select “INPUTS AND OUTPUTS” and press Enter. Configure all of the “Inputs and
outputs” errors; press the Escape button twice to return to the first screen.
To Next Page
Loading...
