Bosch Rexroth CS 440RC - Typical Pre-wetting System

7/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
Liquid
To spray bar
HYDRAULIC PUMP
SOLENOID
OPERATED
VALVES
CS-440 MICROPROCESSOR
Ground Speed Sensor
Flow meter
Liquid pump,
driven by a
hydraulic
motor
To
Hydraulic
Reservoir
Liquid
To spray bar
HYDRAULIC PUMP
SOLENOID
OPERATED
VALVES
CS-440 MICROPROCESSOR
Ground Speed Sensor
Flow meter
Liquid pump,
driven by a
hydraulic
motor
To
Hydraulic
Reservoir
Liquid
To spray bar
HYDRAULIC PUMP
SOLENOID
OPERATED
VALVES
CS-440 MICROPROCESSOR
Ground Speed Sensor
Flow meter
Liquid pump,
driven by a
hydraulic
motor
HYDRAULIC PUMPHYDRAULIC PUMP
SOLENOID
OPERATED
VALVES
SOLENOID
OPERATED
VALVES
CS-440 MICROPROCESSOR
Ground Speed SensorGround Speed Sensor
Flow meterFlow meter
Liquid pump,
driven by a
hydraulic
motor
To
Hydraulic
Reservoir
To
Hydraulic
Reservoir
A typical system consists of a closed loop solid de-icer system. Components making
up a system consist of the following:
• CS-440RC Microprocessor
• Electrically operated conveyor hydraulic valve
• Electrically operated spinner hydraulic valve
• Conveyor speed sensor
• Ground speed sensor
• Conveyor Motor
• Spinner Motor
There are other components such as cables and hydraulic hoses to consider. These
are covered in the Installation Manual and are not covered in the Configuration and
Setting up Manual.
1.3 A Typical Pre-wetting System
Pre-
wetting
The Pre-wetting system:
• CS-440RC Microprocessor
• Electrically operated liquid pump hydraulic valve
• Flow meter