Bosch Rexroth CS 440RC - Setting the Maximum Blast Rate; Setting Blast Rate in Closed Loop Mode

42/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
• Once all the numbers have been changed, press the Enter button.
• Press the Escape button twice to return to the first screen.
12.4 Setting the “Maximum” Blast Rate
Insert the programming key, select “SENSORS AND VALVES”, select “CONVEYOR
SETUP” and select “VALVE SETTINGS”. The screen to the left will appear.
• Use the Down navigation button to move the cursor to “99.99% - BLAST” and
press the Enter button.
• The percentage reflected here is a percentage of maximum conveyor speed.
Thus reducing this percentage will limit the Blast mode output.
• Using the Left or Right navigation button, move the cursor under the number to
be changed.
• Using the Up or Down navigation button, change the number as required.
• Once all the numbers have been changed, press the Enter button.
• Press the Escape button three times to return to the first screen.
12.5 Blast Rate Setting the “Closed Loop”
Insert the programming key, select “MATERIAL SETUP” and select “SOLID 1 - SALT”,
the screen to the left will appear.
• Use the Down navigation button to move the cursor to “0000 - BLAST” and
press the Enter button.
• The RATE reflected here is the actual rate in Kg/Km or lbs/mile as the Blast
mode output.
• Using the Left or Right navigation button, move the cursor under the number to
be changed.
• Using the Up or Down navigation button, change the number as required.
• Once all the numbers have been changed, press the Enter button.
• Press the Escape button twice to return to the first screen.