Bosch Rexroth CS 440RC - Default Chapter; Table of Contents

2/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
Table of Contents
1
11
1 Overview
OverviewOverview
Overview 5
55
5
1.1 CS-440RC Front Layout 6
1.2 A Typical Solid De-icer (Salt/Sand) System 6
1.3 A Typical Pre-wetting System 7
2
22
2 Configuring and Setting Up the CS
Configuring and Setting Up the CSConfiguring and Setting Up the CS
Configuring and Setting Up the CS-
--
-440RC
440RC440RC
440RC 9
99
9
2.1 How to Configure the CS-440RC 9
3
33
3 System Configuration
System ConfigurationSystem Configuration
System Configuration 1
11
12
22
2
3.1 Resetting the Parameters to Default Settings 12
3.2 Setting the Location ID 12
3.3 Setting the Truck ID 12
3.4 Setting the Units of Measurement 13
3.5 Setting the Mode of Control 13
3.6 Setting the Date and Time 14
3.7 Enabling GPS Mode 14
4
44
4 Ground Speed Configuration
Ground Speed ConfigurationGround Speed Configuration
Ground Speed Configuration 15
1515
15
4.1 Overview 15
4.1.1 Driving the Vehicle Over a Measured Distance 16
4.1.2 Auto Calibration Using a Hand Held GPS Unit 17
4.1.3 Auto Calibration Using the GPS Provider’s Ground Speed Signal 17
4.1.4 Auto Calibration Using the Vehicle’s Speedometer 17
4.1.5 Auto Calibration Procedure 17
4.1.6 Verification of Ground Speed 17
4.1.7 Simulated Ground Speed 19
5
55
5 Conveyor Hydraulic Valve Configuration
Conveyor Hydraulic Valve ConfigurationConveyor Hydraulic Valve Configuration
Conveyor Hydraulic Valve Configuration 20
2020
20
5.1 Nulling of the Valve Solenoid 20
5.1.1 Minimum Nulling 20
5.1.2 Maximum Nulling 21
5.1.3 Auto Nulling 21
5.1.4 Forward Gain 22
6
66
6 Conveyor Speed Sensor Configuration
Conveyor Speed Sensor ConfigurationConveyor Speed Sensor Configuration
Conveyor Speed Sensor Configuration 23
2323
23
6.1 Setting the Pulses per Revolution 23
7
77
7 Gate Setting Configuration
Gate Setting ConfigurationGate Setting Configuration
Gate Setting Configuration 24
2424
24
7.1 Selecting the Gate Mode of Operation 24
7.2 Calibrating the Gate “Read Back” Sensor 24
7.3 Closed Loop Gate 25
8
88
8 Material Configuration
Material ConfigurationMaterial Configuration
Material Configuration 26
2626
26
8.1 Naming the Material 26
8.2 Programming the Material Spread Rates 26
8.3 Calibration Procedure 26
8.3.1 Gate Setting for Calibration 26