Bosch Rexroth CS 440RC - Page 3

3/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
8.3.2 Automatic Calibration 27
8.4 Verifying Calibration with Simulated Ground Speed 28
9
99
9 Spinner Hydraulic Valve Configuration
Spinner Hydraulic Valve ConfigurationSpinner Hydraulic Valve Configuration
Spinner Hydraulic Valve Configuration 29
2929
29
9.1 Selecting the Spinner “Mode of Operation” 29
9.2 Selecting the Spinner “Stop” Mode 29
9.3 Adjusting the Spinner Speed 30
9.4 Nulling the Spinner Solenoid 30
9.4.1 Minimum Nulling 30
9.4.2 Maximum Nulling 31
9.4.3 Auto Nulling 31
9.5 Positive Placement System 31
9.5.1 Setting the Spinner Speed Sensor “Pulses per Revolution” 31
9.5.2 Setting the Spinner Maximum RPM 31
9.5.3 Setting the Spinner’s PPS Factor 32
9.6 Spinner Calibration in the “gm/mm2” Mode 32
10
1010
10 Pre
PrePre
Pre-
--
-wetting System
wetting Systemwetting System
wetting System 3
33
33
33
3
10.1 Selecting the Pre-wetting System’s “Mode of Operation” 33
10.2 Selecting the “Solid Reduction” Rate When Liquid is Applied 33
10.3 Naming the Material 34
10.4 Programming the Material Spread Rates 34
10.5 Nulling of the Pre-wet Valve Solenoid 34
10.5.1 Minimum Nulling 34
10.5.2 Maximum Nulling 35
10.5.3 Auto Nulling 35
10.6 Automatic Calibration 36
11
1111
11 Anti
AntiAnti
Anti-
--
-icing Mode
icing Modeicing Mode
icing Mode 3
33
38
88
8
11.1 Simulated Anti-icing Mode 38
11.1.1 Selecting the Simulated Anti-icing Mode 38
11.1.2 Setting the System for Simulated Anti-icing 38
11.1.3 Change LIQUID1 to Read PREWET 38
11.1.4 Entering the Pre-wetting Liquid Rates 38
11.1.5 Change LIQUID3 to Read ANTI-I 39
11.1.6 Entering the ANTI-ICING Liquid Rates 39
11.2 Multiple Boom Anti-icing 39
11.2.1 Selecting the Multi Boom Anti-icing Mode 39
11.2.2 Setting the System for Multiple Boom Anti-icing 40
11.2.3 Change LIQUID3 to Read ANTI-I 40
11.2.4 Entering the Anti-icing Liquid Rates 40
12
1212
12 Blast Mode Configuration
Blast Mode ConfigurationBlast Mode Configuration
Blast Mode Configuration 41
4141
41
12.1 Setting the Solid De-icer Blast “Mode of Operation” 41
12.2 Setting the “Fixed Ration Pre-wetting” Blast “Mode of Operation” 41
12.3 Setting the Blast “Auto Off” Time 41